Astoria-Megler Bridge, Astoria, OR: Location, Length, Height, Toll, History & Facts
Astoria-Megler Bridge begins with a full circle. On the Astoria side, the roadway climbs a 360-degree spiral ramp before sweeping out over the Columbia River toward Washington. The bridge stretches 4.1 miles across the river, just 14 miles from where it meets the Pacific Ocean, carrying US Route 101 from Astoria, Oregon, to Point Ellice near Megler, Washington. It opened in 1966 and is the longest continuous truss bridge in North America. When it was finished, it filled the last gap in US 101, which now runs unbroken from Los Angeles to Olympia. The tolls that paid for it ended in 1993, so crossing is free.

Astoria-Megler Bridge Key Facts
| Detail | Information |
| Other names | Astoria Bridge, Columbia River Bridge |
| Location | Lower Columbia River, between Astoria, Oregon and Point Ellice near Megler, Washington |
| Coordinates | Approx. 46.2170° N, 123.8630° W |
| Highway | US Route 101 |
| Operator | Oregon Department of Transportation (ODOT) |
| Bridge type | Steel cantilever through truss (main section) with long approach spans |
| Designer | William Adair Bugge, with the Oregon and Washington highway departments |
| Builders | DeLong Corporation, American Bridge Company, Pomeroy Gerwick |
| Construction began | November 5, 1962 |
| Opened to traffic | July 29, 1966 |
| Dedicated | August 27, 1966 |
| Construction cost | $24 million |
| Total length | 21,474 ft (6,545 m), about 4.1 miles |
| Cantilever section | 2,468 ft (752 m) |
| Main span | About 1,232 ft (376 m) |
| Clearance above the water | About 196 ft (60 m) at high tide |
| Width | 28 ft (8.5 m) |
| Lanes | 2 (one each way); bicycles share the roadway |
| Spans | 8 main spans and 33 approach spans |
| Piers in the water | 171 |
| Designed to withstand | 150-mph wind gusts and 9-mph river currents |
| Toll | None (removed December 24, 1993) |
| Pedestrians | Not permitted, except during special events |
| Time zone | Pacific Time: UTC−8 (PST), UTC−7 (PDT, second Sunday in March to first Sunday in November) |
Near the Mouth of the Columbia
The Columbia River is one of the largest rivers in North America, and by the time it reaches Astoria it’s several miles wide. The bridge crosses about 14 miles from the river’s mouth, where the Columbia meets the Pacific Ocean at a spot sailors have long respected for its rough waters.
On the Oregon side, the bridge begins in Astoria, the oldest American city west of the Rocky Mountains, known for its Victorian houses on steep hillsides and the Astoria Column. On the Washington side, it lands at Point Ellice, near the old ferry landing at Megler, with US 101 continuing toward Chinook, Ilwaco and the Long Beach Peninsula.
A Four-Mile Crossing
The Astoria-Megler Bridge has two very different parts:
- The main cantilever section, near the Oregon shore, is a steel through truss 2,468 feet long. Its central span, about 1,232 feet, crosses the deep shipping channel.
- The long approach spans stretch out toward Washington, running low over the water on a string of piers for most of the crossing.
- The total length is 21,474 feet, about 4.1 miles.
- Over the shipping channel, the deck clears the water by about 196 feet at high tide, high enough for large ocean-going ships heading upriver to Portland and Longview.
- The bridge is 28 feet wide, with one lane in each direction.
- It rests on 171 piers in the river.
Engineers designed the bridge for the tough conditions at the mouth of the Columbia. It can handle wind gusts of up to 150 miles per hour and river currents of up to 9 miles per hour.
No Toll Today
The Astoria-Megler Bridge is free in both directions. It was paid for with tolls when it opened, and the tolls were removed on December 24, 1993, more than two years ahead of schedule.
Tips for drivers:
- The bridge has only one lane in each direction and no shoulders over much of the crossing. Keep a steady speed and stay in your lane.
- Cyclists are allowed and share the roadway with cars. Drivers should give them plenty of space.
- On windy days, high-profile vehicles like RVs and trailers can feel strong crosswinds. Check ODOT’s travel updates for any restrictions.
- On the Astoria side, the spiral ramp is tight, so slow down as you enter or leave the bridge.
From Ferry to Bridge
Before the bridge, the only way across this stretch of the Columbia was by ferry. Ferry service between Astoria and the Washington shore began in 1926, and the Oregon highway department took it over in 1946. The trip took about half an hour, and the ferries couldn’t run in bad weather, which often left travelers waiting.
Oregon and Washington worked together to plan a bridge. Construction began on November 5, 1962. The concrete piers were cast at Tongue Point, a few miles upriver. The steel sections were built about 90 miles up the Columbia in Vancouver, Washington, then floated down on barges and lifted into place with hydraulic jacks.
The bridge opened to traffic on July 29, 1966. The official dedication on August 27, 1966, drew more than 30,000 people for four days of celebrations, including parades and a boat race from Portland to Astoria. Oregon Governor Mark Hatfield and Washington Governor Dan Evans cut the ribbon.
The Great Columbia Crossing
Once a year, the bridge closes to traffic for the Great Columbia Crossing, a 10K run and walk from Washington to Oregon, usually held in October. It’s the only time most people get to walk across the bridge, since pedestrians aren’t allowed on normal days. Participants start on the Washington side and finish in Astoria, crossing the whole river with views of ships, the Pacific and the Astoria hills. Check the event’s official website for the current year’s date and registration.
What to See Nearby
The bridge is the centerpiece of a region full of history and natural beauty:
- The Astoria Column, on a hill above town, offers panoramic views of the bridge, the Columbia River and the Pacific.
- The Columbia River Maritime Museum, on Astoria’s waterfront, tells the story of the river’s shipping history and its famous sandbar.
- The Astoria Riverwalk runs along the waterfront, with close-up views of the bridge and ships passing beneath.
- Fort Clatsop, part of Lewis and Clark National Historical Park, recreates the winter camp of the Lewis and Clark Expedition in 1805–1806.
- On the Washington side, Cape Disappointment State Park and the Long Beach Peninsula are a short drive away.
- Astoria is also known for its role in films like The Goonies, and many visitors stop by movie locations around town.
FAQs
Q1. Is there a toll on the Astoria-Megler Bridge?
A. No. Tolls on the Astoria-Megler Bridge were removed on December 24, 1993, and the bridge is now free to cross.
Q2. How long is the Astoria-Megler Bridge?
A. The Astoria-Megler Bridge is 21,474 feet long, or approximately 4.1 miles (6.6 km).
Q3. How high is the Astoria-Megler Bridge?
A. The bridge provides approximately 196 feet of clearance above the Columbia River at high tide over the main shipping channel.
Q4. When was the Astoria-Megler Bridge built?
A. Construction began on November 5, 1962. The bridge opened to traffic on July 29, 1966, and its official dedication took place on August 27, 1966.
Q5. Is the Astoria-Megler Bridge the longest truss bridge in North America?
A. Yes. The Astoria-Megler Bridge is widely recognized as the longest continuous truss bridge in North America.
Q6. Can you walk across the Astoria-Megler Bridge?
A. Pedestrians are generally not permitted to walk across the bridge on normal days. Walking access is provided during the annual Great Columbia Crossing event.
Q7. Can you bike across the Astoria-Megler Bridge?
A. Yes. Cyclists can cross the Astoria-Megler Bridge, but they share the roadway with motor vehicles and should follow applicable traffic and safety rules.
Q8. What does the Astoria-Megler Bridge connect?
A. The bridge connects Astoria, Oregon, with Point Ellice near Megler, Washington, across the Columbia River. It carries U.S. Route 101 between Oregon and Washington.
Q9. Who designed the Astoria-Megler Bridge?
A. The Astoria-Megler Bridge was designed by William Adair Bugge, working with the Oregon and Washington highway departments.
Q10. How much did the Astoria-Megler Bridge cost?
A. The bridge cost approximately $24 million to construct in the 1960s. Toll revenue was subsequently used to help pay off the construction bonds.



Post Comment